Mobile Flame ionization detector, Bernarth Atonic, FID, type BA 3006. SN: 4346. Year 9/2000. Purchased for 85296 dkk
Complete with hoses, distributer and printer.
Double-sided (can measure on two sides at once)
Technical specifications: (3006 model)
Measured componentsHydrocarbons, chlorinated hydrocarbons
Temperature of analytical chamber: 200 (60-240) °C
Warm-up time: approx 15 minutes
Indicator: Analog meter with reflection-free scale
Measuring Ranges: smallest range 1ppm relative to C3H8. Largest range 10% by volume
Linearity: up to 100,000ppm, between a decade range, ±1%, over the complete measuring range ±5%
Detection Limit: <1.5% of final value of measuring range, smallest value 15ppb C3H8
Detection signal rise time (T90): <0.9 seconds
Consistency of results: 30 - 200 (repeated measurement will obtain the same value)
Zero Drift: < 0.5% of reading/month
Span drift: < 2.8% of reading/week
O2-sensitivity at: 0%, 5%, 10%, 15%, 21%
O2 with 80ppm C3H80: 9%, 0.3%, -1.1%, -1.8%, 0.0%
Ambient air pressure: < 0.5% of reading / 10hPa
Sample gas pressure: < 1.0% of reading / 10hPa
Ambient Temperature Zero Point: <2% of reading/10 °K
Ambient Temperature Span Point: <1% of reading/10 °K
Sample Gas Pressure Range: atmospheric, ± 100 hPa
Temperature: 0 to 240°C at the sample gas entry of the analyser
Sample Gas Flow: approx. 1.2 l/min
Connection: stainless steel compression fitting, for tube outer diameter 6mm (0.24"), inner diameter 4mm (0.1")
Analog Outputs: 0/4 to 20 mA, load resistor: max 500 ohms and 0 to 10 V, load resistor min 10 kOhms
Measuring Range: 0 to 5 V, in steps of 1 V, potential divider status with 1+1+1+1+1+5 kOhms bleeder to 10V
Binary Outputs: Operation status: contact relay, 250V AC, 6 A thresholds: centre-zero relay, 250V AC, 6A
Power Supply: AC 230V 48 - 63 Hz
AC 120V 48 - 63 Hz
Power Consumption: During warm-up approx. 500VA, during continuous duty 200 VA without heated sample line
